Hidden danger investigation of Kaiping machine and precautions for tool replacement

How can we avoid accidents when using a Kaiping machine, which comes with some dangerous situations? Firstly, we should learn how to check the hidden dangers of the flatbed machine and pay attention to the precautions when replacing tools. So next, the editor will take you to learn how to check the hidden dangers of the Kaiping machine and the precautions when replacing tools.
1. Hazard investigation
It is necessary to conduct a thorough hazard investigation before starting work on the Kaiping machine. Firstly, check the installation integrity of the bottom line to determine if the circuit contacts are intact. Suitable power supply should be provided according to the specified rated parameters. At the same time, it is necessary to ensure the stability of the power supply to prevent poor contact. Secondly, try to use original accessories produced by the manufacturer and avoid modifying the straightening machine as much as possible. At the same time, regularly wipe the appearance and seals of the machine tool to achieve a rust free and oil-free state as much as possible. At the same time, clean the work roll and drive shaft to ensure normal operation without cracks.
During the inspection of hidden dangers in the operation of the Kaiping machine, if smoke or abnormal noise is found, the Kaiping machine should be immediately shut down and stopped working. Otherwise, a fire may occur and the power supply needs to be cut off. According to the requirements, it is necessary to maintain the Kaiping machine, check for hidden dangers, and extend the service life of the Kaiping machine. Only when all parts of the Kaiping machine are intact and the machine is clean, can the Kaiping machine work better.
2. Precautions
(1) Pay attention to the opening machine before changing the tool, and make sure to switch the unit operation mode from linked to single action.
(2) Do not raise the blade shaft too high to avoid damaging the arch.
(3) When changing the knife, no one is allowed to rotate the knife shaft, and unrelated personnel should stay away from the operation button.
(4) It is prohibited to use a wrench to hook the nut and rotate the blade shaft to disassemble and install the nut on the Kaiping machine.
(5) When disassembling and installing the tool kit, handle it with care with both hands.
(6) When installing the blade, be careful to prevent the blade from cutting your hands. Do not use blades with notches or obtuse angles.
(7) After changing the blade according to the planned board requirements, carefully check the width of the strip, and then manually test the cutting edge.
The above are precautions for identifying hidden dangers and changing knives in the Kaiping machine. After these studies, I believe you have learned how to investigate the hidden dangers before starting the flattening machine and the precautions when changing knives. I believe you have already received a certain degree of protection, but you still need to pay attention in your work!
Editor: Karry